|

Stylet-Oil
is compatible with most agricultural chemicals and can be
applied as a tank mix with them. Where
problems are encountered,
the
incompatible chemicals
are phytotoxic when used alone and the oil aggravates this toxicity. Consult a current label or contact JMS Flower Farms, Inc.
for information regarding compatibility.
Chemical Incompatibility
Can Occur
When:
- incompatible chemicals are tank mixed with the oil
- incompatible chemical residue has dried on the inside of the spray tank and the oil
dissolves the residue at the time of oil application
- incompatible chemical residue is on the plant at the time of the oil application
Mixing
Procedures ―
1.
Add ¼ to ½ of
the liquid amount of water
to the tank mix
2.
Start agitator before adding any tank mix
partners. In general, tank mix partners
should be added in the following order:
Products
Packaged in Water
Soluble Packaging;
Wettable powders;
Wettable granules (dry flowables);
Liquid formulations;
Liquids;
Emulsifiable concentrates;
and, add mineral oil as the last ingredient.
NOTE:
Certain chemicals (such as
Rally / Nova brand fungicide) are packaged in water soluble packages which are not
oil soluble. We recommend these products be mixed in a clean 5-gallon bucket of water
before adding to the spray tank water. Add the oil to the spray tank as the last
ingredient.
3.
Provide sufficient agitation while adding
the remainder of the
water.
4. Maintain agitation until
all the mixture
has been applied
General
Information:
- add the oil to the tank mix as the last ingredient
- local climatic conditions can adversely affect the persistence of oil on a crop
- on crops where a tank mix or a spray interval has not been used before, spray a small
area with the recommended nozzles and pressure, then wait several days to observe
potential for phytotoxicity
- chemicals which are phytotoxic when used alone will be more phytotoxic when used with
the oil
- when other products are tank mixed with Stylet-Oil the other products should be used
only in accordance with their specific label directions
Partial List of Compatible Chemicals
The following products have been observed to be chemically
and physically compatible with Stylet-Oil as a tank mix:
Insecticides:
| Bacillus thuringiensis (Bt) formulations |
Asana 1 |
Monitor |
| Orthene |
Cygon |
Malathion |
| Lannate |
Vydate |
Thiodan |
| Admire (Confidor) |
Agri-Mek |
Diatomacious earth |
| Diazinon |
Vendex |
Success (Tracer, Spinosad) |
| Sevin |
Applaud |
Azo-Direct |
| Assail |
Actara |
PyGanic |
| Esteem |
Apollo |
Pyramite |
| FujiMite
2 |
Ecozin |
|
1
tomatoes only; 4 to 6 oz per 100 gals
2
hops
may exhibit a temporary yellowing of young foliage
Fungicides:
| Benlate |
Kocide 2 |
Ridomil |
| Rally (Nova) |
Dithane |
Rovral |
| Tilt |
Abound (Quadris) |
Procure |
| CopperCount-N 1,2 |
Maneb |
Bayleton |
| Rubigan |
Mancozeb |
Topsin |
| Thiram |
Elite |
Orbit |
| Folicur |
Flint |
Pristine |
| Cabrio |
Sovran |
Quintec |
| Armicarb
3 |
Kaligreen
3 |
Elevate |
| Ziram |
|
|
1
One quart per 100 gals
2
On grapes: Do not use
copper and oil together with fruit present.
3
Add oil to the tank mix as the LAST ingredient,
otherwise a gooey mess
may result.
Nutrient
Sprays:
- urea @ 3 to 5 lb per 100 gals
- Epsom salts1 @ 3 to 5 lb per 100 gals
- ionized foliar sprays2 (20-20-20;
NutriLeaf; Bayfolan) @ 3 to 5 lb per 100 gals
- minor elements ( such as Sequestrene 330) @ 1 lb per 100 gals
- apply chelated micro nutrients (Keyplex) separately
1
Magnesium sulfate
2
The label shows
incompatibility but this refers to use rates over 3 lb per
100 gals
Partial List of Incompatible Chemicals
The following products have been observed to be
CHEMICALLY INCOMPATIBLE
with Stylet-Oil and should NOT be tank mixed. Spray these products separately
with a 14 day interval preceding or following an oil application:
Insecticides:
| Ambush, Pounce |
Sulfur 1 |
M-Pede / detergents / soaps |
| Kelthane 2 |
Omite 3 |
|
Fungicides:
| Dyrene |
Botran |
Dikar |
| Sulfur
1 |
Bravo 4 |
|
Adjuvants:
- Nu-Film-P, Nu-Film-17, pinolene-based products
5
- spreader / stickers 5
- organosilicone surfactants
6
1
On grapes: Do not apply
sulfur within 10 days of an oil application. On all other crops: Do not
apply micronized sulfur within 10 days of an oil application and do not apply oil within
14 days of wettable or dusting sulfur.
2
Do not use Kelthane in a spray program
with Stylet-Oil on ornamentals or
strawberries.
3
Do not use Omite
with an oil spray. Do not apply Omite within 30 days of
an oil application.
4 On cucurbits, do not use in a spray
program with Stylet-Oil. Wait at least
21 days between an oil application and a Nu-Film-P
application.
5 Do not tank mix Stylet-Oil with Nu-Film-P or
Nu-Film-17 (pinolene-based
products). Wait at least 10 days between an oil application and
spraying
pinolene-based products.
6 Never tank mix Stylet-Oil with a
spreader / sticker or an organosilicone
surfactant. Wait at least until the foliage has
dried before applying oil after
an application using these products.
Chemicals
NOT to be Used With Stylet-Oil
Do not use before, during or following a Stylet-Oil
application:
| Captan |
Folpet |
| Morestan |
Organic tin compounds (Du-Ter) |
| Guthion
1 |
|
1
Do not use Guthion during, with or following an oil application
on cherry.
Additional Information:
- Do not use Bravo or Cygon in a spray program with Stylet-Oil on grapes, ornamentals and
strawberries
- Always read and follow label directions.
|